Partner Tech P4-18XT Uživatelský manuál

INSTRUCTION MANUALIMPORT ANT INFORMATION: Plea se read th ese inst ructi o ns carefull yand make sure you understand th em bef o re using th is unit.

10CUTTING METHODSIMPORTANT POINTSS Check chain tension before first use andafter 1 minute of operation. See CHAINTENSION in the ASSEMBLY section.S Cut

11S Be alert to signs that the tree is ready tofall: cracking sounds, widening of the fell-ing cut, or movement in the upperbranches.S As tree starts

12LIMBING AND PRUNINGWARNING: Be alert for and gua rdagainst kickback. Do not allow the movingchain to contact any other branched or objectsat the nos

13BAR MAINTENANCEIf your saw cuts to one side, has to be forcedthrough the cut, or been run with an improperamount of bar lubrication it may be necess

14CAUTION: It is important to preventgum deposits from forming in essential fuelsystem parts such as the carburetor, fuel fil-ter, fuel hose, or fuel

15TECHNICAL DATA SHEETP33XTEngine P351XT P4-18 XT 4- 20XTCylinder volume,cm346 46 46Stroke, mm 32 32 32Idle speed, rpm 3000 3000 3000Recommended max.s

2IDENTIFICATION (WHAT IS WHAT?)ChainAdjustment Tool(Bar Tool)Primer BulbFuel Mix Fill CapStarterHousingBar OilFill CapChainFront Hand GuardFront Handl

3IDENTIFICATION OF SYMBOLSMove ON/STOP switch tothe ON position.Slowly press primer bulb6times.Pull the starter ropesharply 5 times with yourright han

4S Do not put pressureon the saw at the endofthe cut. Applying pressure can cause you tolose control when the cut is completed.S Stop the engine befor

5S T urn the engine off and let saw cool in anon-combustible area, not on dry leaves,straw, paper, etc. Slowly remove fuel capand refuel unit.S Storet

6S Keepagood, firmgriponthesawwithbothhands when the engine is running anddon’tlet go. A firmgripwillhelpyoureducekickback and maintain control of the

7ATTACHING THE BAR & CHAIN(If not already attached)WARNING: Recheck each assem-blystepifthesawisreceivedassembled.Al-ways wear gloves when handlin

8AdjustingScrewChain Brake NutsGuide BarAdjusting Screw -- 1/4 TurnS Lift up the tip of the bar and securely tight-en the chain brake nuts with the ba

9STARTING A COLD ENGINE (or awarm engine after running out offuel)NOTE:Inthefollowingsteps,whenthecho-ke/fast idle lever is pulled out to the full ex-